Baby Changing Station Height

The act regulates baby changing stations in the following ways.

Baby changing station height.

For horizontal changing stations the ada requires that the unit protrude no more than 4 from the wall and be no higher than 27 inches from the floor. See figure s 308 2 a. Ada regulations also state that baby changing stations must be located in an area that is easily accessible and free from obstructions. Often made from an abrasion resistant plastic a baby changing table may be treated with an antimicrobial protection to help reduce and prevent bacteria growth.

Protruding objects units are not to protrude more than 4 inches from the wall when closed. The handle used to pull the station bed down must be no more than 48 inches from the floor. This product is designed for infants only up to 3 5 years of age and weighing less than 50 lbs. Height width and depth.

The station bed when open and laid flat must not require the person changing the child to lift the baby more than 34 from the floor. Where a forward reach in unobstructed the high forward reach shall be 48 inches 1220 mm maximum and the low forward reach shall be 15 inches 380 mm minimum above the finish floor or ground. Knee clearance must extend 25 inches under a changing table and the unit must be 9 inches above the finish of the ground. Horizontal stainless steel recess mounted kb110 ssre.

Install at the perfect height. When the unit s bed is opened and laid flat it must provide adequate knee clearance below the station. The ada mandates that baby changing stations be present in both men s and women s restrooms and must be placed at a height of 27 inches from the floor. Recess mounted stainless steel clad baby changing station is the premier choice for upscale restroom facilities.

This is required so patrons using wheelchairs can easily access the unit as well as open and close the changing station. 8365328 8276229 d605886 d601843 canadian patent no. Disposable liners are usually sold separately and should be easy to dispense and refill. Figure 308 2 a forward reach.

A diaper changing station will have the following dimensions specified. 130179 european community 1114367 0001 1114367 0002 australia patent no. This baby changing station has been tested to support 200 lbs with minimal deflection.